DHT-22 digital temperature and humidity Sensor


35 Items

Low-cost digital temperature and humidity sensor

17.00 AED

16.19 AED AED tax excl.

The DHT22 is a basic, low-cost digital temperature and humidity sensor with a single wire digital interface. The sensor is calibrated and doesn’t require extra components so you can get right to measuring relative humidity and temperature. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin. It requires careful timing to grab data.

Simply connect the first pin on the left to 3-5V power, the second pin to your data input pin and the right most pin to ground. Although it uses a single-wire to send data it is not Dallas One Wire compatible! If you want multiple sensors, each one must have its own data pin!

Note: Its needs a 4.7k~10k Pullup resistor on the data line, so make sure to use on the data line, alternatively check this DHT22 Sensor Module we have, it comes with onboard pullup and decoupling capcitor on the supply line.


  • 3 to 5V power and I/O
  • 2.5mA max current use during conversion (while requesting data)
  • Good for 0-100% humidity readings with 2-5% accuracy
  • Good for -40 to 80°C temperature readings ±0.5°C accuracy
  • No more than 0.5 Hz sampling rate
  • Body size 27mm x 59mm x 13.5mm (1.05" x 2.32" x 0.53")
  • 4 pins, 0.1" spacing


QuantityDiscountYou Save
10 10% Up to 17.00 AED
50 15% Up to 127.50 AED
100 20% Up to 340.00 AED

26AWG, 20 CM Male to Male Jumper wire

5.00 AED

26AWG, 20 CM Female to Female Jumper wire

5.00 AED

26AWG, 20 CM Male to Female Jumper wire

5.00 AED

Set of commonly used 1/4 Watt resistor

25.00 AED

Select pack of 10 resistors from list of range we offer

2.50 AED

Related Products