AM2315 - Encased I2C Temperature/Humidity Sensor

ER-1056

2 Items

Warning: Last items in stock!

Adafruit Product ID: 1293

136.50 AED

130.00 AED AED tax excl.

These are the I2C compatible temperature & humidity sensor in a nice enclosed style. This sensor contains a DS18B20 temperature sensor and a capacitive humidity sensor. The microcontroller inside does the readings and provides a simple I2C interface for reading the formatted calibrated output data. This sensor comes in a rugged case with mounting bracket useful for tough conditions.whereas it is not rated as 'weatherproof', this sensor would do much better for sensing where there might be wind, rain and heat.

Simply connect the red wire to 5V power, black to ground, yellow wire to your i2c data pin, and the white wire to the i2c clock pin. You cannot change the i2c address so only one sensor per i2c bus. Two ~10Kohm pullup resistors are required for use, connect from the SDA and SCL lines to the power wire, the pullup resistors are not included!

Specifications:

  • 3.5 to 5.5V power and I/O
  • 10 mA max current use during conversion (while requesting data)
  • Good for 0-100% humidity readings with 2% accuracy
  • Good for -20 to 80°C temperature readings ±0.1°C typical accuracy
  • 0.5 Hz update rate
  • Body size 98mm x 16mm diameter (4" x 0.9" )
  • 4 wires 20 inches long
  • Weight: 82.64g
  • This board/chip uses I2C 7-bit address 05C.

AM2315 datasheet

Image and content taken from Adafruit

Related Products