Electret Microphone - 20Hz-20KHz (Pack of 2)

ER-446

10 Items

1.50 AED

This electret condensor microphone contains a small vibrating element that will output a few milllivolts peak-to-peak. You will need an op-amp to amplify the signal, some chips are designed with the amplifier built in in which case you can wire it up directly. You can plug it into a PCB, breadboard, perfboard or solder wires to the little wires sticking out the back.

Mounting Type: Through Hole

26AWG, 20 CM Male to Male Jumper wire

5.00 AED

26AWG, 20 CM Female to Female Jumper wire

5.00 AED

26AWG, 20 CM Male to Female Jumper wire

5.00 AED

Two Channel Operational Amplifier

1.00 AED

Set of commonly used 1/4 Watt resistor

20.00 AED

Select pack of 10 resistors from list of range we offer

1.50 AED