Digital Tilt Switch/Angle Sensor module

ER-373

29 Items

Tilt Switch Angle sensor Module for Raspberry Pi and Arduino.

8.00 AED

This module is perfect to send signals to microcontroller, whenever an object/body tilt is detected, its a cheap replacement for Accelerometer just to detect the tilt, four of these mounted in 4 direction, will help you to understand the tilt of the object or the body on which this module is mounted. It comes with a 3mm mounting screw hole to fit into any surface. It works with multiple voltage Input.


Specification:
  • On-board LM393 voltage comparator chip and tilt sensor probe.
  • Supports 5 V / 3.3 V voltage input.
  • The comparator outputs  Clean signal, good waveform and it has good driving ability, more than 15mA.
  • The output format: digital switching outputs (0 and 1).
  • Signal detection sensitivity can be adjusted using potentiometer.

26AWG, 20 CM Female to Female Jumper wire

5.00 AED

26AWG, 20 CM Male to Female Jumper wire

5.00 AED

Related Products