SparkFun Pi Wedge (Preassembled)



GPIO Breakout Board for Raspberry Pi (To be used with Breadboard).
Check this New Raspberry Pi GPIO Breakout Board -40 pin here

52.50 AED

This is the SparkFun Pi Wedge, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi and breaks the pins out to breadboard-friendly arrangement and spacing, and even adds a couple of decoupling capacitors on the power supply lines. The “Wedge” also makes the initial bring-up process easier - you can plug an FTDI Basic module into the built-in serial port. Each version of this Pi Wedge comes preassembled and can be inserted into the RPi’s GPIO port that allows you to prototype - no soldering required!

The Pi Wedge is compatible with the Raspberry Pi A+, B+, RPi2 or RPi3 models and it adapts the GPIO header on the RPi to a standard solderless breadboard. If you love the Raspberry Pi and have been looking to start prototyping with it look no further than the SparkFun Pi Wedge!

  • 1x Preassembled SparkFun Pi Wedge
  • 1x GPIO Ribbon Cable (40-pin, 6")


Image and Content Credit: Sparkfun

26AWG, 20 CM Male to Male Jumper wire

5.25 AED

26AWG, 20 CM Male to Female Jumper wire

5.25 AED

The Raspberry Pi 3 is the third generation of the Raspberry Pi .

199.50 AED

This kit now comes with Heat sink, perfect kit for beginners

319.00 AED

Kit Contains all the items to get started

319.20 AED

Open Source Media Center Kit with configurable MINI IR Remote

329.70 AED

Open Source Media Center Kit comes with Configurable IR Remote

329.70 AED

Related Products