2 Item Items
Warning: Last items in stock!
Imagine 5 networks in one perfectly-formed, same-small-foot-print-as WiPy and LoPy, IoT development board. MicroPython enabled. FiPy includes WiFi, Bluetooth, LoRa, Sigfox and dual LTE-M (CAT M1 and NBIoT) the FiPy gives access to all the world’s LPWAN networks on one tiny board.
Note: The Fipy works for all CatM1 and NB-IoT bands worldwide. We strongly recommend ordering an LTE-M Antenna for best performance.
Get on with a board that gives you full flexibility during testing, install, deployment and even later when you want to switch real-time your airtime network provider. You can switch when the time is right for you or set some parameters that will do so automatically.
|Espressif ESP32 SoC|
|Dual processor and WiFi radio system on chip|
|Networking processor handles the WiFi connectivity and the IPv6 stack|
|Main processor is entirely free to run the user application|
|An extra ULP-coprocessor that can monitor GPIOs, the ADC channels and control most of the internal peripherals during deep-sleep mode while only consuming 25uA|
|2 x UART, 2 x SPI, I2C, micro SD card|
|ANalog channels: 8×12 bit ADCs, 2×8 bit DAC|
|Timers: 2×64 bit with PWM with up to 16 channels|
|DMA on all peripherals|
|GPIO: Up to 22|
|Hash / Encryption|
|SHA, MD5, DES, AES|
|Low energy and classic RTC|
|Running at 32KHz|
|Node range: Up to 50km|
|Security & Certifications:|
|SSL/TLS support up to 1.2|
|WPA Enterprise security|
|AES encryption engine|
|Flash Memory: 8MB|
|GPIO: Up to 22|
|Hardware floating point acceleration|
|Voltage Input: 3.3V – 5.5V|
|3v3 output capable of sourcing up to 400mA|
|Pycom modules are powered by the NEW and FEATURE PACKED Espressif ESP32 chip. As a result our firmware is evolving constantly as the ESP32 IDF matures. Regular firmware updates are therefore provided.|