PIR Motion Sensor


27 Items

High sensitive passive infrared(PIR) motion sensor with stable digital output

10.00 AED

9.52 AED AED tax excl.

This is High sensitive passive infrared(PIR) motion sensor with stable digital output. PIR sensors are useful to detect motion from intruders, animals from about 7 meter away. It has an adjustable delay before firing (approx 2-4 seconds), adjustable sensitivity and You need  jumper wires (Not Included) to connect to this module.It Runs on 5V-12V power (if you need to run it off of 3V you can do that by bypassing the regulator, but that means doing a bit of soldering). Digital signal output is 3.3V high/low. Sensing range is about 7 meters (120 degree cone)

  • Operating voltage: DC5V to 20V
  • Static power consumption: 65 microamps
  • level output: high-3.3V, low-0V
  • Delay Time: adjustable (0.3 seconds to 18 seconds)
  • Embargo time: 5 seconds
  • Trigger Jumper supports: L(Single Trigger), H (Repeat Trigger), bydefault the Single trigger is set.
  • Sensing range: less than 120 degrees angle, 7 meters

26AWG, 20 CM Female to Female Jumper wire

5.00 AED

26AWG, 20 CM Male to Female Jumper wire

5.00 AED

The Arduino UNO Rev3 is based on the Atmega328 just like its predecessor, but it replaces the FTDI for the 16U2, this enables much faster upload speeds.

95.00 AED

The MEGA 2560 is designed for more complex projects. With 54 digital I/O pins, 16 analog inputs and a larger space for your sketch it is the recommended board for 3D printers and robotics projects. This gives your projects plenty of room and opportunities.

160.00 AED

Related Products