Waveshare 3.5inch TFT LCD (A), 320x480

ER-1159

This product is no longer in stock

320×480, 3.5 inch Touch Screen TFT LCD Designed for Raspberry Pi

136.50 AED

130.00 AED AED tax excl.

Please visit this link for Getting Started and driver installation Instruction

Features:

  • 320×480 resolution
  • Resistive touch control
  • Supports any revision of Raspberry Pi (directly-pluggable)
  • Drivers provided (works with your own Raspbian/Ubuntu directly)
  • Size perfectly fits the Pi
  • High quality immersion gold surface plating
  • Supports Raspbian system, enables your system to:
    • Take photos by touching (up to 17 camera modes)
    • Support software keyboard (system interaction without keyboard/mouse)

Note: 3.5inch RPi LCD (A) and 3.5inch RPi LCD (B) are hardware compatible with each other (uses different driver), and can be mutually substituted in most cases. (A) for low cost ver. while (B) for IPS ver. with better displaying.

.

Parameters:

LCD TypeTFT
LCD InterfaceSPI
Touch Screen TypeResistive
Touch Screen ControllerXPT2046
Colors65536
BacklightLED
Resolution320*480 (Pixel)
Aspect Ratio8:5
Power ConsumptionTBD
Backlight CurrentTBD
Operating Temp. (℃)TBD

.

Interface:

PIN NO.SYMBOLDESCRIPTION
1, 173.3VPower positive (3.3V power input)
2, 45VPower positive (5V power input)
3, 5, 7, 8, 10, 12, 13, 15, 16NCNC
6, 9, 14, 20, 25GNDGround
11TP_IRQTouch Panel interrupt, low level while the Touch Panel detects touching
18LCD_RSInstruction/Data Register selection
19LCD_SI / TP_SISPI data input of LCD/Touch Panel
21TP_SOSPI data output of Touch Panel
22RSTReset
23LCD_SCK / TP_SCKSPI clock of LCD/Touch Panel
24LCD_CSLCD chip selection, low active
26TP_CSTouch Panel chip selection, low active

.

FAQ:

  • Why the LCD doesn't work with my Raspbian?

To use the LCD with the Raspberry Pi official image, driver should be installed first. Please refer to the user manual.
However, for the first testing, you may want to use our provided image directly.

  • Why the LCD still doesn't work with the Waveshare provided image?

Make sure the hardware connection is correct and connects fine.

Make sure the image in TF card is burnt correctly.

The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully, in case both of the two LEDs keep on, it is possible that the image was burnt incorrectly OR the TF card was in bad contact.

  • Which power supply should I use?

It is strongly recommended to use a stand-alone 5V/2A power adapter, because the PC's USB port might have not enough power to support the Pi and LCD.

.

Images and Contents from Waveshare

Related Products