Circuit Scribe - DIY Board


1 Item

Warning: Last items in stock!

The DIY Board allows you to create a module from any component with 8 pins or fewer. The numbers next to the feet corresponds to the numbers on the pads. The board has five sections; You can break the sections to make multiple, customized boards. 

36.75 AED

35.00 AED AED tax excl.

The DIY Board allows you to connect a more complicated chips to your traces. The chips can have up to 8 pins and can be soldered to the pads or inserted into the through holes. However, through hole components can be harder to use do to varying wire thicknesses. The numbers next to the feet indicate the pin number that it attaches to at each component insertion spot. Breaking apart the different sections breaks the connection between the feet and their corresponding pins in other sections and allows you to customize your board. Apart from the four spots for components with up to 8 pins, there is a spot for a 2-pin component between feet 9 and 10. 

Contents and Images credit: Circuit Scribe Website

The NPN Transistor acts as a switch or amplifier. With no current at the base, there will be no current flow from collector to emitter. However, a small amount of current to the base will allow a large current to flow through the collector and emitter.

31.50 AED

Our connectors allow you to connect a drawn trace to a socket on external hardware such as a breadboard, Arduino, or Makey-Makey.

52.50 AED

The Blinker module turns a direct current input into a square wave output, allowing you to make LEDs blink and Buzzers beep. It has a green LED flashing in time with the output and a red LED to indicate if power is connected the wrong way. You can change the blinking rate by turning the wheel!

42.00 AED

The Motor module operates between 8V and 12V. By flipping the module around, you can get the motor spinning in either direction. It comes with a soft foam wheel to visualize its rotation, but you can also create your own propellers or paper crafts to put on top!

63.00 AED

The Buzzer module plays a 4kHz tone. The volume of the buzzer can be adjusted by changing the the amount of power running through it. The plus and minus signs indicate the direction in which it operates.

36.75 AED

The USB Adapter module supplies 5V to your circuit when plugged into a USB port. It has a blue LED to indicate that power is being supplied to the module and a red LED to indicate if the module has been shorted.USB cable is included.

42.00 AED

Related Products