Circuit Scribe - Basic Kit

ER-313

2 Items

170.00 AED

The Basic Kit contains a Circuit Scribe pen, six modules, a 9V Battery and other accessories to improve your circuit drawing experiences (see below for full list). This kit allows you to explore basic electronics concepts, beyond what the Lite Kit offers. The five additional modules allow you to expand your knowledge of transistors, resistance, elements in parallel and series, open and short circuits, and more.

6 Modules:
  • 9V Battery adapter with 9V battery 
  • x2 Bi-LED 
  • SPST Switch
  • NPN Transistor
  • 2-Pin Adapter with 5x resistors (100, 1k, 10k, 100k and 1M ohm), 2x capacitors (0.1uF, 1.0uF), and one photoresistor (10k ohms)
Additional Items:
  • Conductive Ink Pen
  • Circuit Stencil 
  • Jumper Sticker Sheet
  • Workbook (Optional) 
  • Steel sheet

Contents and Images credit: Circuit Scribe Website

The DIY Board allows you to create a module from any component with 8 pins or fewer. The numbers next to the feet corresponds to the numbers on the pads. The board has five sections; You can break the sections to make multiple, customized boards. 

35.00 AED

The NPN Transistor acts as a switch or amplifier. With no current at the base, there will be no current flow from collector to emitter. However, a small amount of current to the base will allow a large current to flow through the collector and emitter.

30.00 AED

Our connectors allow you to connect a drawn trace to a socket on external hardware such as a breadboard, Arduino, or Makey-Makey.

50.00 AED

The Blinker module turns a direct current input into a square wave output, allowing you to make LEDs blink and Buzzers beep. It has a green LED flashing in time with the output and a red LED to indicate if power is connected the wrong way. You can change the blinking rate by turning the wheel!

40.00 AED

The Motor module operates between 8V and 12V. By flipping the module around, you can get the motor spinning in either direction. It comes with a soft foam wheel to visualize its rotation, but you can also create your own propellers or paper crafts to put on top!

60.00 AED

The Buzzer module plays a 4kHz tone. The volume of the buzzer can be adjusted by changing the the amount of power running through it. The plus and minus signs indicate the direction in which it operates.

35.00 AED

The USB Adapter module supplies 5V to your circuit when plugged into a USB port. It has a blue LED to indicate that power is being supplied to the module and a red LED to indicate if the module has been shorted.USB cable is included.

40.00 AED

Perfect kit to start prototyping using paper and conductive Ink 

95.00 AED

Related Products