DIP HDMI Adapter

ER-247

This product is no longer in stock

C.H.I.P. HDMI DIP

96.00 AED

HDMI DIP is accessory board that give new capabilities to C.H.I.P.  It gives higher resolution HDMI video output.C.H.I.P.s (with the proper software) automatically recognize when a DIP is attached and act accordingly. 

The HDMI DIP allows C.H.I.P. to connect to a monitor or television via an HDMI cable at a maximum resolution of 1920 by 1080 at 30Hz (a.k.a, 1080p). This DIP only provides a video signal over the HDMI cable: there is no audio encoded with it.

Features:
  • Maximum Resolution: 1920 x 1080 at 30Hz
  • Power switch: This is located on the top edge of the PCB, as it is close to impossible to access it.
  • Prototyping area - There is “Proto board” on the PCB itself. This is convenient if you would like to add a small circuit to your DIP, without having to add another board.
  • U14 partial breakout - This makes it easy to access the GPIO, UART, audio, and ground pins.
  • Volts - 5V & 3V voltages are available below the NTC proto area.
  • HDMI connector - A standard HDMI connector is used to send your video to a monitor, and is located at the bottom of the PCB.
  • The Video Processor is the brains of the HDMI DIP. It takes the video from the LCD_Dx pins.

Requirements:
  • C.H.I.P. with C.H.I.P. OS 1.1 with Debian 4.4 kernel
  • HDMI display
  • HDMI cable
  • 2A+ power adapter and micro USB cable

Supported Resolutions:

We cannot provide an exhaustive list of all resolutions, since this can depend on the attached monitor, but here are some observed resolutions:

  • 1360x768
  • 1920x1080
  • 1680x1050
  • 1280x1024
  • 1280x960
  • 1280x800
  • 1280x720
  • 1024x768
  • 800x600
  • 720x480
  • 640x480
  • 720x400

HDMI DIP GUIDE