Adafruit Raspberry Pi Camera Board Case with 1/4" Tripod Mount


10 Items

Warning: Last items in stock!

Clear/Black Polycarbonate Flange Mount Electronic Enclosure


20.00 AED

19.05 AED AED tax excl.

This is a classic Adafruit Raspberry Pi Camera Board Enclosure, it comes with a black base and a clear top, the two pieces  made of polycarbonate will snap snugly together. It will keep your Pi Camera safe and secure while also looking super sleek. You can fit in Pi Camera v1 and v2 inside this, the enclosure was designed by Mike Doell. It is Made up of ultra-durable, super-glossy polycarbonate, it is both good looking and tough enough to toss into your pocket, bookbag, or toolbox. It has an easy-to-access slim opening for your camera cable to extend out from the camera module. The camera board sits nicely in the base, latching to the four little pegs, and the lid fits snugly on top. There's also a tiny hole in the lid so not to distort the capturing of images.

It comes with a 1/4" tripod mount nut, so you can attach it to anything with a standard tripod screw. Note that to keep the enclosure compact it comes with a slim nut - so attach the case carefully and make sure not to push the tripod screw through the camera

Note: the Pi Camera v2 (8 Megapixel) is just a bit thicker than the original, which might cause the camera to press against the case and cause blurry images, depending on how it is focused. The easiest way to fix is remove the sticky-rubber spacer that is between the camera module and PCB. Gently remove the camera module from the PCB, peel off the spacer, and re-plug the camera module. Problem solved! 

This product comes with 2 case pieces only. Raspberry Pi Camera Board is not included. No other cables or connectors or accessories are included!


Product Dimensions: 50.0mm x 31.0mm x 12.8mm / 2.0" x 1.2" x 0.5"

Product Weight: 7.5g / 0.3oz

Contents and Images from Adafruit
QuantityDiscountYou Save
10 10% Up to 20.00 AED
50 15% Up to 150.00 AED
100 20% Up to 400.00 AED

Related Products