3mm Mercury Tilt Switch

ER-374

102 Items

Tilt Switch Angle sensor for Raspberry Pi and Arduino.

1.00 AED

This Sensor is perfect to send signals to microcontroller, whenever an object/body tilt is detected. This tilt switch can easily be used to detect orientation. Inside the can is a ball that make contact with the pins when the case is upright. Tilt the case over and the balls don’t touch, thus not making a connection.There are numerous uses for these basic sensors. These are cheap replacement for IMU just to detect the tilt, four of these mounted in 4 direction, You need breadboard or Proto board to use this sensor.


Specification:

  • Supports 5 V / 3.3 V voltage input.
  • The output format: digital switching outputs (0 and 1).

26AWG, 20 CM Female to Female Jumper wire

5.00 AED

26AWG, 20 CM Male to Female Jumper wire

5.00 AED

Set of commonly used 1/4 Watt resistor

20.00 AED

Select pack of 10 resistors from list of range we offer

1.50 AED

Related Products