CAN-BUS Shield

ER-575

1 Item

95.00 AED

The CAN-BUS Shield provides your Arduino or Redboard with CAN-BUS capabilities and allows you to hack your vehicle. This shield allows you to poll the ECU for information including coolant temperature, throttle position, vehicle speed, and engine rpms. You can also store this data or output it to a screen to make an in-dash project.

It uses the Microchip MCP2515 CAN controller with the MCP2551 CAN transceiver. CAN connection is via a standard 9-way sub-D for use with OBD-II cable. Ideal for automative CAN application. The shield also has a uSD card holder, serial LCD connector and connector for an EM506 GPS module. These features make this shield ideal for data logging application.

Note: A DB9 Cable is not included with this shield. Please be sure to check Recommended Products section below for a recommended cable to use with this board.

Note: This product is a collaboration with SK Pang Electronics. A portion of each sales goes back to them for product support and continued development.

Features:

  • CAN v2.0B up to 1 Mb/s
  • High speed SPI Interface (10 MHz)
  • Standard and extended data and remote frames
  • CAN connection via standard 9-way sub-D connector
  • Power can supply to Arduino by sub-D via resettable fuse and reverse polarity protection.
  • Socket for EM506 GPS module
  • Micro SD card holder
  • Connector for serial LCD
  • Reset button
  • Joystick control menu navigation control
  • Two LED indicator

Documents:

Image and content credit : Sparkfun

26AWG, 20 CM Female to Female Jumper wire

5.00 AED

26AWG, 20 CM Male to Female Jumper wire

5.00 AED

PCB Solderable Male Header 40 Pins, 1 Row

1.50 AED

PCB Solderable Female Header 40 Pins, 1 Row

1.50 AED

40 x 1 Male Header: 90 Degree 

1.50 AED

66 Satellites Channel GPS Module - Comes with 5 pin Right Angle Solderable Header

229.00 AED

Connector for CAN BUS Shield

42.50 AED