SparkFun Opto-isolator Breakout

ER-410

2 Items

19.00 AED

This is a board designed for opto-isolation. This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or noisy system. This board electrically isolates a controller from the high-power system by use of an opto-isolator IC. This IC has two LEDs and two photodiodes built-in. This allows the low-voltage side to control a high voltage side.

We often use this board to allow a microcontroller control servos or other motors that use a higher voltage than the TTL logic on the (3.3V or 5V) micro, and may cause electromagnetic interferance with our system as the motors turn on and off. This board will isolate the systems, creating a type of electrical noise barrier between devices.

This breakout board uses the ILD213T optoisolator and discrete transistors to correct the logic. Comes with two channels. Great for use in noisy circuits where signal lines require electrical isolation.

A normal LED opto-isolator will invert the logic of a signal. We threw some transistors on this compact board to correct the inversion. What you put into the IN pins, will be replicated on the the OUT pins, but at the higher voltage (HV).

Documents:

Image and Content Credit: Sparkfun

26AWG, 20 CM Male to Male Jumper wire

5.00 AED

26AWG, 20 CM Female to Female Jumper wire

5.00 AED

26AWG, 20 CM Male to Female Jumper wire

5.00 AED

PCB Solderable Male Header 40 Pins, 1 Row

1.50 AED

PCB Solderable Female Header 40 Pins, 1 Row

1.50 AED

40 x 1 Male Header: 90 Degree 

1.50 AED

Related Products