SparkFun Pi Wedge (Preassembled)


GPIO Breakout Board for Raspberry Pi (To be used with Breadboard).
Check this New Raspberry Pi GPIO Breakout Board -40 pin here

47.25 AED


52.50 AED

This is the SparkFun Pi Wedge, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi and breaks the pins out to breadboard-friendly arrangement and spacing, and even adds a couple of decoupling capacitors on the power supply lines. The “Wedge” also makes the initial bring-up process easier - you can plug an FTDI Basic module into the built-in serial port. Each version of this Pi Wedge comes preassembled and can be inserted into the RPi’s GPIO port that allows you to prototype - no soldering required!

The Pi Wedge is compatible with the Raspberry Pi A+, B+, RPi2 or RPi3 models and it adapts the GPIO header on the RPi to a standard solderless breadboard. If you love the Raspberry Pi and have been looking to start prototyping with it look no further than the SparkFun Pi Wedge!

  • 1x Preassembled SparkFun Pi Wedge
  • 1x GPIO Ribbon Cable (40-pin, 6")


Image and Content Credit: Sparkfun

26AWG, 20 CM Male to Male Jumper wire

4.73 AED 5.25 AED -10%

26AWG, 20 CM Male to Female Jumper wire

4.73 AED 5.25 AED -10%

The Raspberry Pi 3 is the third generation of the Raspberry Pi .

179.55 AED 199.50 AED -10%

This kit now comes with Heat sink, perfect kit for beginners

287.10 AED 319.00 AED -10%

Kit Contains all the items to get started

287.28 AED 319.20 AED -10%

Open Source Media Center Kit with configurable MINI IR Remote

296.73 AED 329.70 AED -10%

Open Source Media Center Kit comes with Configurable IR Remote

296.73 AED 329.70 AED -10%

Related Products